Easy Methods in Keeping your Water Heater in Mint Condition

Plumber Mosman

After the installation of your brand new water heater, you don’t have to go all-out when it comes to its maintenance. But if it’s been a year since the installation of the equipment, then you definitely need to start doing intensive upkeep. A thorough maintenance is even more necessary for homeowners that have their water heater in their house for quite some time. Check out these tips on how to keep your water heater in mint condition.

Drain the Tank

    It’s one of the best ways to care for your water heater. Some may think that the tank doesn’t need to be drained since it pumps water all the time anyway, which is an awful advice. You see, the tank can easily accumulate debris and lime scale from minerals, especially if the water heater is used a lot. If the tank has too much deposits, then it will most likely stop producing hot water and can even become broken. This is why you should give importance in draining the tank. There are a lot of suggestions on the frequency of flushing out the water heater, some would say once a year is sufficient or a couple of times each year. What you need to do is refer to the manual of your water heater which is provided by the manufacturer for the required number of flushes it needs each year.

Keep the temperature between 115 to 120°F

    This maintenance tip is more on the daily usage of the equipment. Anyway, be sure to always dial the temperature of your water heater between 115 to 120°F. This is to ensure that it won’t overheat or increase the water pressure. Even if your water has the capacity to go beyond 120°, you should not set the temperature too high. This is because regardless of the capacity of the tank; the metals will contract since it’s always exposed to high temperature. Keeping the temperature between 115 to 120°F can also lower the energy consumption of the water heater. Another thing, going below the recommended setting is also not a good idea since certain pathogens and bad bacteria may start developing in the tank, which is extremely dangerous.

Install an Expansion Tank

    For those of you who are not using tankless heating systems, it’s advisable to install an expansion tank. What does it do? Well, it’s simply an additional tank that increases the water and pressure capacity of the water heater’s basic tank. Just think of it as some sort of “space allowance”. An expansion tank will definitely help regulate the increased water volume and temperature of the water heater.


    You must check your water every month for any possible leaks, damage, and among other alarming symptoms that show your water heater is dysfunctional. Also, be on the lookout for possible corrosion that is coming from both inside and outside the tank. Check if your anode rod isn’t too rusty or short. There may also be suspicious sounds that you may notice when using the fixture. It can be tedious to check every single part of your water heater but it’s needed for proper maintenance. Of course, you can always hire a plumber or water heater specialist to have a more profound inspection.

Contact Us

Book a Job Or Request For Expert Advise